Bulk 3D Printing Quote - Upload Many STL Files at Once | Pookie Prints
Bulk Quote

Thirty Models,
One Quote Run.

Drop the whole folder. Set material, colour and quality once - override any single file that needs something different - then price the lot in one pass and send it all to your cart.

Just one file? Use the single-file quote with a live 3D viewer →

Default print settings

Every file uses these unless you override it below.

Material
Colour
Layer height
Infill 20%
10%100%
New files always start with these settings.

Drop your STL files here

or click to browse - select as many as you like

STL only • max 100 MB per file • max 250 × 250 × 250 mm • up to 50 files per batch

Common questions about batches

STL files up to 100 MB, and up to 250 × 250 × 250 mm. Your file is sliced with the real print profile, so the weight and time in the quote are measured rather than guessed.
Both cost ₹4/g. PLA comes in five colours and suits indoor decor, toys and prototypes, but softens near 55 °C; PETG is Black or White only, tougher and heat-tolerant to about 75 °C - the pick for outdoor, wet or mechanical parts.
0.2 mm is the default and the right choice for most models. 0.1 mm gives fine detail but is slower and dearer; 0.3 mm is draft quality - fastest and cheapest.
20% is right for most prints. More infill means a stronger, heavier part and a higher price; less means lighter and cheaper.
Material (weight in grams × ₹4) + printing (minutes × ₹1.50), plus 18% GST and shipping - the total shown already includes all of them, with shipping estimated at the ₹80 base zone. Your PIN code sets the exact shipping at checkout, whose total is always the authoritative figure.
You are paying for weight and print time, so lower infill, 0.3 mm layers or a smaller scale all bring the price down. Switching material will not - PLA and PETG are both ₹4/g.